SPINRET EXTRUSION full electric plastic injection molding machine advantage

Date:2022-7-19 Author:Sam

The advantages of full electric plastic injection molding machine: the advantages of energy saving and low noise, high repetitive accuracy maintenance, high reliability, etc., are in line with the development trend of international plastic injection molding machines in recent years. The specifics are as follows:

1. High accuracy: The servo motor is used as a source of power, and a simple and high -efficiency transmission mechanism is composed of roller screws and synchronous belts. Its duplicate accuracy error is 0.01%.

2. Save energy: The energy released during the deceleration phase in the working cycle can be converted into electric energy reused, thereby reducing the operating cost, which is more than 50%compared to the corresponding hydraulic driving plastic injection molding capacity, connecting the connection Electricity Xinchen Extrusion The device is only 25%of the power equipment required by hydraulic driver plastic injection molding machine.

3. Precision injection control: Make the product close to the limit of injecting the raw material, the melting screw position is controlled by digital precision, reducing the back pressure , Food industry and other plastic products with high accuracy and cleanliness.

4. Improve the level of environmental protection: Due to the reduction of energy varieties and its optimized performance, the pollution source has decreased, and noise has been reduced. It provides a better guarantee for the environmental protection work of the factory.

5. Reduce noise: The running noise value is less than 70 decibels, which is about 2/3 of the noise value of hydraulic driving plastic injection molding machine noise.

6. Save cost: This machine removes the cost of hydraulic oil and the troubles caused by it. There is no hard pipe or soft throat, no need to cool down the hydraulic oil, and greatly reduce the cost of cooling water.

7. The production cycle is short. For example: at the 2002 Shanghai International Plastic Machinery Exhibition, Japan Nissei exhibited an ES200 full electric plastic injection molding machine. A product production cycle is only 0.63s (seconds), the molding time is 0.1 seconds, and the mold opening is 0.13 seconds.